Friday, April 24, 2009

More Swimsuit Sewing Tips

As I was sewing suits this week I remembered a couple more items that I should point out. Click HERE for the posting of my first set of tips.

Topstitching
I use one of two decorative stitches for topstitching down the elastic in swimsuits. You attach the elastic on the wrong side of the swimsuit with a loose zig zag and then as you fold it in towards the inside of the suit you finish it off with one of the two stitches below.

Katelyn asked me on the last post if I would show a pic of what I meant by "loose" zigzag stitch. I hope this helps. On my machine my stitch length goes from 1 to 4. I normally sew on about a 3. For basting or gathering I move the stitch length to 4. So as I zigzag I leave it on a stitch length of 3. That is what is shown below. Those black lines are a 1 inch grid on my cutting board.
This picture shows what it looks like if I adjust the stitch length to almost a 2. It is way too close together. Here is a little side by side comparison.
Decorative Stitches for Topstitching
#1 The Three Step Zig-Zag (My preferred choice!!) Here shown on a neck edge of a swimsuit.
or
#2 In my machine manual it is called a Smocking Stitch (it is found under my Three Step Zig-Zag stitch)

Shell or Lettuce Edge
I use this on the hem of the ruffled skirt on the swimsuit or cover-up skirt. It can also be used on the hem edges and sleeve hems of t-shirts.

It looks like this:

To make it you set your machine to it's shell stitching setting (blind hem stitch).
If you have your machine's manual look in the index for "Shell Stitching". Play around on a scrap piece of fabric first because picking this stitch out is NOT fun. And some fabric will "shell" a lot easier than others so you'll have to adjust your stitch lengths.

The Shell Stitch is formed by sewing a blind hem over a folded piece of fabric.

  • Set the stitch length as you desire. (On my machine I have to adjust it clear down to 1 1/2 in order to get the "shell" or "scallop" that I like)

  • You may need to tighten the top thread tension slightly.

  • Allow the needle to just clear the folded edge of the fabric when it zigzags.

Also, make sure you have plenty of bobbin thread before starting this. If you run out mid-hem it is not as easy to match up as you would think.

If you have any other questions, send them our way. If we know the answer we'll try and explain it. If not, we'll see if we can find it somewhere. That is one thing about sewing--there is more than one way to do something.

2 comments:

  1. Thank you so much, years later and still such a help... this is my first time for a leotard and it kept skipping, found from your post i am using the wrong needle.. thank you for your post and helping :D Godspeed

    ReplyDelete

LinkWithin

Related Posts Plugin for WordPress, Blogger...